sponsor

sponsor

Slider

Recent Flow

Magnetic flow meter

Installasi flow meter

Digital Flow Sensor

Flow meter

ULTRASONIC FLOW METER

Flow meter Air Limbah

» » » » » Parker JD-100 Diaphragm Level Switch Type For powder

Liquid Level switch | Parker Level Switch | Powder Level switch

JD-100 Diaphragm Level Switch Parker

Features

  • Sensitivity can be easily adjusted using an internal high strength spring
  • Since the structure is simple, troubles occur rarely and maintenance is easy
  • Easy handling and wiring

Specification

Item UnitJD-100 Level switch
Contact point capacityAC 250V 5A, DC125V 0.5A
Pressure usedAtmospheric pressure (ATM)
Torque500~1000 g/cm
Operating Temperature60°C
Ambient Temperature0~60°C (Provided that, there should be no freezing)

Application

Fluid UsedUse divisionScope of application
Powder, Granules, LumpsGrains, Cement, Sand, FlourWheat flour, Soybean, Feed, Sugar, Sand, etc.

Dimension

Wiring

Example Of Installation

Precaution For Installation

  • Check the voltage of the power supply. The built-in small motor requires a predetermined voltage which cannot be adjusted.
  • Carefully review places to be selected for installation-The wings should not come into contact with parts such as steel piers in silos or tanks -Avoid places where powder drops. Upper limit switches should be installed vertically to have the device exert its performance.
  • When the switch has been installed outdoors, problems may easily occur in electric piping in particular. If the level switch is lower than the wiring duct as shown in the figure, rainwater many flows into the electric piping and into the main body of the level switch in rainy seasons. Therefore, please pay special attention to this matter.
  • The level switch is mechanical and has a small built-in synchronous motor(torque: 0.1-1kgf/cm). Therefore, please be careful so that no foreign matter or impurities would go into the level switch while being installed.
  • If the pressure is applied to the diaphragm surface by powder in the silo or tank, the built-in micro-switch will operate due to the force. If there is no powder in the silo or tank, the switch will be automatically restored by the force of the built-in spring. When necessary, the internal spring’s force may be adjusted to adjust the sensitivity.
  • caution does not use this switch in use environments where the rubber diaphragm may be damaged.

More information please Email Marketing@wmablog.com

«
Next
Posting Lebih Baru
»
Previous
Posting Lama

Tidak ada komentar:

Most Wanted

Top Article

Flowmeter Ultrasonic

Flowmeter ultrasonic  adalah jenis    flow meter yang prinsip kerjanya mengukur  kecepatan aliran suatu fluida dengan menggunakan ultra so...